After the sealing is increased, it will be reduced, or not this circumstance occurs. (6) Sealing: When cutting the inner hole, because of the lead-in and lead-out lines, sometimes there will be a notch, which will damage the contour of the workpiece and fill in later. The incorrect value of the final "part to part" value will cause the wrong size of the whole board. When adding parts that do not need co-edging, "Part Adjust the value of "Part to part" to the standard cutting interval, such as 10mm, but remember when outputting the code, change the value of "Part to part" back to the slit value and then output the code, because the part will use the last set value before output as the part Cutting compensation. If some parts in the nesting need to be co-edged and some do not need to be co-edged, when adding parts that require co-edging, the value of "parts to parts" is set to the slit value, such as 2mm. (5) Common edge cutting is suitable for flame cutting, not for plasma cutting because the cutting surface of plasma cutting is relatively oblique, and the angle is larger. Only pierce once and cut continuously to reduce gun head loss. (4) Automatic continuous cutting As long as in the FastPATH setting, check the "cut short gap line" and enter the short gap length to achieve this efficient cutting. (3) Cutting workpieces of different sizes When cutting workpieces of different sizes on a steel plate, the small pieces should be cut first, and then the large pieces.
0 kommentar(er)
